|
|
> Slimline Design
Heatmiser thermostats are designed to be
neat and tidy. Their flush mount design means the depth is only 13mm after
installation.
> Mains Powered
Greater convenience - no batteries
required.
>
Blue Backlight
Activated by any key press, this feature
enables easy programming of the thermostat.
> Remote
Control
On selected models, you are able to
control your thermostat by infrared remote control
> Override
Facility
Quickly and easily override your
programmed settings.
|
|
|
Our mains powered digital thermostat products enable
the replacement of existing mechanical thermostats. These thermostat
products can be used in conjunction with the
UH2, our mains voltage central wiring
switch box. All of our thermostats require at least three
wires, so you should check this before ordering.
Tip ! If you are replacing an
existing mechanical thermostat, you should check that you have
the correct number of wires at the thermostat before ordering.
All these thermostats are mains powered, and so therefore need a
permanent 230v supply. So, a minimum of 3 wires is needed for
these thermostats to operate.
|
Heatmiser DT - Digital Room Stat
The DT is our digital
room thermostat, ideal for conventional or combi-boiler
systems. This thermostat does not have a time-clock
so is normally used with a separate time-clock.
Tip! For much greater control of your heating
system, consider placing your existing time-clock into
"Constant Mode" and opting for the Heatmiser PRT
instead.
-
3A Volt free Terminals (Standard)
-
KeyLock Facility
-
Adjustable Frost Temp
Setback
-
°C °F Selectable
-
05-35°C
room temperature
See the Heatmiser DT in our Shop
Heatmiser PRT - Programmable Room Stat
The PRT is our 5/2 day
programmable room stat Providing up to
4 different temperatures at different times of the day -
so allowing you to program the temperature required
according to the occupancy of your home. Our
programmable room thermostat is 13mm deep after
installation!
-
3A Volt free terminals
(Standard)
-
Keylock Facility
-
Adjustable Frost Temp
Setback
-
°C °F Selectable
-
Optimum Start (Energy
saving feature)
-
Changeover
terminals available
-
05-35°C
room temperature
See the Heatmiser PRT in our Shop
Heatmiser PRT/HW
The PRT/HW is our 5/2 day
digital
programmable thermostat with an additional 5/2 day program
for the domestic hot water cylinder. Reduced costs and
wiring means the PRT/HW really is an all-in-one solution.
-
3A volt free terminals
(Standard)
-
05-35°C
room temperature
-
Keylock Facility
-
Adjustable Frost Temp
Setback
-
°C °F Selectable
-
Optimum Start (Energy
saving feature)
See the Heatmiser PRT/HW in our Shop
 |
|
